The FIBARO Smoke Sensor is a small, light-weight device with an aesthetically pleasing design and manufactured from robust materials. It uses temperature and photoelectric sensors to easily detect flaming or smouldering fires, the device is loaded with an acoustic alarm and RGB indicator. No need for unsightly wiring or complicated installation, the device is battery powered and simple to use. The sensor is also equipped with a built in electronic recording device, to better analyse incidents.

End Node

End nodes transmit and receive data with the home centre relevant to their status in the network.

Looks grate, works great

The FIBARO Smoke Sensor is furnished with a highly polished grille, but its not just there to look great. In fact its one of the devices most important features, the electrochemically shaped perforations help guide even the smallest amount of smoke into the sensors inner chamber.

Smarter than it looks

Not all fires are the same and some materials burn without smoking, so the engineers at FIBARO included a temperature sensor. The device will detect rapid changes in temperature and read them as a threat.

Stronger than it looks

The FIBARO Smoke Sensor is manufactured from materials resistant to heats of up to 200 degrees celsius, threats and alerts are stored on the main controller and sensor’s memory for detailed analysis of incidents.

The heat of the moment

Just as fires are not all the same, room temperatures and uses can also vary. This can make determining if there is fire present in a room more difficult, and requires a subtle approach. To prevent false alarms the FIBARO Smoke Sensor’s sensitivity can be calibrated for the room it resides in. Where smoke and heat is unexpected such as a bedrooms, the sensitivity should be set to maximum to ensure a speedy response time. In rooms where heat and smoke is to be expected such as boiler rooms and kitchens, the sensitivity can be set lower to avoid being triggered.

Fully integrated

In an emergency there is no time to waste and every second counts, get out of the building and let your system take care of the rest. Integrating the FIBARO Smoke Sensor into your networked devices allows the system to run complex scenes in the event of an alarmed event.

I’m listening

The FIBARO Smoke Sensor combined with the Home Center, gives you the ability to communicate with your sensors via voice control.

Features

• Compatible with any Z-Wave or Z-Wave+ Controller
  
• Supports protected mode (Z-Wave network security mode) with AES-128 encryption
  
• Extremely easy installation – simply install it in location prone to fire
  
• Battery powered
  
• 3 levels of sensors sensitivity
  
• Built-in casing opening detector
  
• Alarm is signalled by sound, visual indicator and Z-Wave control command
  
• Programmable excess temperature warning
  
• Automatic test performed every 10 seconds
  

Manuals

FIBARO Smoke Sensor Operating Manual (Z-Wave)

FIBARO Smoke Sensor Short Manual (Z-Wave)

FIBARO Smoke Sensor Short Guide (Z-Wave)

Videos